Re: [LUG] Raspbery Pi still not working...

[JOHN DAVEY <johndavey303@xxxxxxxxxxxxxx>]

---

From: stinga <stinga+dclug@xxxxxxxxxxxxx>
To: list@xxxxxxxxxxxx
Sent: Thursday, 21 February 2013, 14:32
Subject: Re: [LUG] Raspbery Pi still not working...

On 21/02/13 14:21, JOHN DAVEY wrote:

On Feb 21, 2013 1:40 PM, "JOHN DAVEY" <johndavey303@xxxxxxxxxxxxxx> wrote:

Hi, I have posted about this here before and was given the advise to get a HDMI to DVI cable so that my Pi will work on my monitor but I have bought two (just in case one was faulty) of these leads but the devise still wont display on my monitor. Like I said I have no problems when it is connected to the TV but just fails completely to make anything display on my 'acer' monitor. I am sure it's not a problem with the monitor so any ideas ?
Thanks for any suggestions, Jon

It is possible your monitor is a dvi-a and not a dvi-d? (not that I know much about this sort of stuff)

-- 
'ooroo

Stinga...(:)-)
---------------------------------------------------
Email: stinga+dclug@xxxxxxxxxxxxx   o
You need only two tools.        o /////
A hammer and duct tape. If it    /@   `\  /) ~
doesn't move and it should use  >  (O)  X<  ~  Fish!!
the hammer. If it moves and      `\___/'  \) ~
shouldn't, use the tape.           \\\
---------------------------------------------------

--
The Mailing List for the Devon & Cornwall LUG
http://mailman.dclug.org.uk/listinfo/list
FAQ: http://www.dcglug.org.uk/listfaq

...knowing my luck I expect it is Stings...  :(   Is there any way I can tell except that my Pi will not run on it ?
Jon.

-- 
The Mailing List for the Devon & Cornwall LUG
http://mailman.dclug.org.uk/listinfo/list
FAQ: http://www.dcglug.org.uk/listfaq