Thanks for the reply. I currently cannot access the Draytek
because it is sharing the same IP address as the Netgear. I am
assuming if I disconnect the Draytek from the netgear, log into
the Draytek as 192.168.0.1 and change it then. Will that work
please?
Hi Richard.
Simply put...
Use the Netgear for DHCP.
Turn DHCP Server Off on the Draytek.
Assign the Draytek a static IP (not 192.168.0.1 but something
in the DHCP pool)
Turn Off WiFi on the Netgear
That'll do it for now - unless someone else on the list wants
to explain subnets.
On 06/11/2018 14:31, Richard Brown
wrote:
Hi
I have been given a lovely piece of kit by a lug member. I
need to now set this up and I am wondering if I could have
some help please?
I now have a Netgear DGN2200v4. This is serving as a router
and dhcp server. It also provides wifi.
The new piece of kit is a Draytek Vigor 2130 Series Broadband
Router/Firewall.
So, I now want to switch off all functionality in the Netgear
and let the Draytek take over, using the Netgear simply as a
modem.
Both bits of equipment are using the ip address of
192.168.0.1. When I type that in a browser, I get access to
the Netgear. The Draytek is connected via cable to the Netgear
and currently displays a wifi identity as Draytek with no
protection. I can log into the wifi and use it.
I tried turning off the Netgear as a DHCP server and lost the
internet completely and so I reset that and I am now once
again functioning.
I am assuming that if I tell the Netgear to use IP address
192.168.0.250 say, this will then allow me to connect to the
Draytek. Is that correct please, if not can someone tell me
the steps to take in order to let the Draytek take over and
secure the Network please?
Thanks
